Subsidiary Settings; Video Plus+ Setup - JVC HR-S7700EK Instructions Manual

SUBSIDIARY SETTINGS

VIDEO Plus+ Setup

IMPORTANT
Normally, Auto Set Up (
automatically. You need to set the Guide Program Numbers manually only in the following cases.
When timer-programming with the VIDEO Plus+ system, the preset position, where the station you wish to record is received
on your recorder, is not selected or when you add a channel after Auto Set Up or Auto Channel Set has taken place.
— Set the Guide Program Number for that station manually.
When you wish to timer-record a satellite programme with the VIDEO Plus+ system.
— Set the Guide Program Numbers for all satellite broadcasts received on your satellite receiver.
Turn on the TV and select the VIDEO channel (or AV mode).
Guide Program Number Set
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS INITIAL SET
SCREEN
2
Press % fi to move the highlight bar (pointer) to
"INITIAL SET", then press OK or
ACCESS GUIDE PROG SET
SCREEN
3
Press % fi to move the highlight bar (pointer) to "GUIDE
PROG SET", then press OK or
ENTER GUIDE PROG
NUMBER
4
Press % fi to enter the
Guide Program number for
the desired station as shown
in the TV listings. Then
#
press OK or .
pg. 8), Preset Download (
#
.
#
.
GUIDE PROG SET
GUIDE PROG TV PROG
4 5
[5∞] =
[0] : SAT
[MENU] : EXIT
(Ex.) When inputting the
Guide Program
number 4 for CH4.
pg. 9) or Auto Channel Set (
ENTER RECEIVING PRESET
POSITION NUMBER
5
Press the NUMBER key "0"
to select "TV PROG" or
"SAT". Then press % fi to
input the number of the
preset position on which
the Guide Program
number's broadcast is
received by the recorder or
the satellite receiver. Then
press OK or
To timer-record a
satellite programme with
VIDEO Plus+, you need
to install the provided Satellite Controller and
perform the procedure described in "Satellite
Receiver Control Setting" (
Repeat steps 4 and 5 as necessary.
RETURN TO NORMAL
SCREEN
6
Press MENU.
Guide Program Number
"Guide Program (GUIDE PROG) number" refers to the
assigned TV station numbers, according to broadcast area, for
the VIDEO Plus+ timer recording. The Guide Program
numbers can be found in most TV listings.
pg. 48) sets the Guide Program Numbers
GUIDE PROG SET
GUIDE PROG
4
[5 ∞ ] =
[MENU] : EXIT
#
.
(Ex.) If CH4 is received on
preset position 4.
pg. 12).
45
TV PROG
4
CH4
[0] : SAT