Jenn-Air 30"GAS DOWNDRAFT SLIDE-IN Installation Instructions Manual page 20

30" (76.2 cm) gas downdraft slide-in ranges
Table of Contents

Advertisement

Available languages

Available languages

Adjust Flame Height
Adjust the height of top burner flames. The cooktop "low" burner
flame should be a steady blue flame approximately ¼" (0.64 cm)
high.
A
B
A. Low flame
B. High flame
To adjust standard burners:
The flame can be adjusted using the adjustment screw in the
center of the valve stem. The valve stem is located directly
underneath the control knob.
If the "low" flame needs to be adjusted:
1. Light 1 burner and turn to lowest setting.
2. Remove the control knob.
Hold the knob stem in the low position using a pair of pliers. Use
an ¹⁄₈" (3.0 mm) flat-blade screwdriver to turn the screw located in
the center of the control knob stem until the flame is the proper
size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
5. Repeat above steps for each burner.
To adjust double burner:
1. Light burner and turn to lowest setting where both inner and
outer burners are lit.
2. Remove the control knob.
20
Insert an ¹⁄₈" (3.0 mm) flat-blade screwdriver into adjustment
locations shown in the following illustration and engage the
slotted screw. Turn the screw until the flame is the proper size.
3. Replace the control knob.
4. Test the flame by turning the control from "LO" to "HI,"
checking the flame at each setting.
Check Operation of Oven Bake Burner
1. Remove the oven rack.
2. Using a Phillips screwdriver, remove and set aside the 2 oven
bake burner cover screws located at the front of the oven.
A
B
A. Bake burner cover
B. Bake burner cover screws
3. Lift up and remove oven bake burner cover.
4. Unscrew 2 wing nuts and remove oven baffle.
A
A. Oven baffle
B. Wing nuts
B

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jgs9900cdr

Table of Contents