Jenn-Air 30"GAS DOWNDRAFT SLIDE-IN Installation Instructions Manual page 18

5. Plug range electrical connector into the downdraft blower
motor.
A. Power supply cord
B. Range electrical connector to blower motor
6. Remove cardboard or hardboard from under the range. Using
2 or more people, gently move range into its final location.
7. Check that the anti-tip bracket is installed and that the
flexible connector and electrical cord are not kinked. Use a
flashlight to look underneath the bottom of the range.
Look for the anti-tip bracket securely attached to floor or
wall.
Slide range back so rear range foot is under anti-tip
bracket.
18
8. Level the range.
a.) Place rack in oven.
b.) Place level on rack and check levelness of the range, first
side to side; then front to back.
A
c.) If range is not level, pull range forward until rear leveling
leg is removed from the anti-tip bracket.
d.) Use a wrench or pliers to adjust leveling legs up or down
until range is level.
e.) Push range back into position.
B
f.) Check that rear leveling leg is engaged in anti-tip bracket.
NOTE: Range must be level for satisfactory baking
performance.
9. Depending on your installation, connect the flexible vent from
the blower motor inlet to the range using a vent clamp.
Wall Venting
C
Top View
B
A
A. Range
B. Wall venting outlet
C. Vent clamp