Draytek Vigor2760 Series User Manual page 50

VLAN Encapsulation
PPPoE Pass-through
Settings
Advanced Settings
Apply
Clear
Cancel
3. After finished the settings above, click Apply to save the settings then click Cancel to
return to previous page.
Always On box.
Enable the function of VLAN with tag. The router will add
specific VLAN number to all packets while sending them
out. Please type the tag value and specify the priority for the
packets sending by the router.
VLAN ID –Type the value as the VLAN ID number. The
range is form 1 to 4000.
Priority (802.11) - Type the packet priority number for such
VLAN. The range is from 0 to 7.
The router offers PPPoE dial-up connection. Besides, you
also can establish the PPPoE connection directly from local
clients to your ISP via the Vigor router. Thus, the PC can
access Internet through such direction. Check the box to
enable such function.
PPPoE Pass-through Interface – It is available when
PPPoE Pass-through Settings is enabled.
ATM QoS – Such configuration is applied to upstream
packets. Such information will be provided by ISP. Please
contact with your ISP for detailed information. Select a
proper QoS type for the channel according to the information
that your ISP provides.
The default setting is "0".
Peak Cell Rate –
Cell Delay Variation –
Minimum Cell Rate – The default setting is "0"..
Sustainable Cell Rate – The value of Sustainable Cell Rate
(SCR) must be smaller than PCR(Peak Cell Rate).
Maximum Burst Size – The default setting is "0".
MAC Address – Check to box to display the MAC address
field and type the MAC address here.
Management - Enable the checkbox to allow system
administrators to login from the Internet. There are several
servers provided by the system to allow you managing the
router from Internet. Check the box(es) to specify.
Click it to save the settings.
Click it to remove the modification of the web page.
Click it to return to previous web page.
42
The default setting is "0".
Vigor2760 Series User's Guide