Unpacking; Setup; Scope Of Delivery; Mains Supply Or Battery Operation - KERN GAB Operating Instructions Manual

6.2 Unpacking

Carefully remove the balance from the packaging, remove plastic cover and setup
balance at the intended workstation.

6.2.1 Setup

Level balance with foot screws until the air bubble of the water balance is in the
prescribed circle.

6.2.2 Scope of delivery

Serial accessories:
KERN GAB / GAS / FAB
• Balance
• Operating Manual
• Mains adapter

6.3 Mains supply or battery operation

Power is supplied via the external mains adapter. The stated voltage value must be
the same as the local voltage.
Only use original KERN mains adapters. Using other makes requires consent by
KERN.
Output voltage mains adaptor: 3.2 V to 6.0 V CD (polarity: inside PLUS)
The balance switches off automatically according to the pre-defined disconnecting
time. To achieve this, keep the MODE key pressed down for 6 seconds, then tap the
MODE key repeatedly and store the selected disconnecting time by pressing the
TARE key.
The following applies:
• P 0: Balance not turning off.
•
P 1: Balance turning off automatically after 20 minutes
•
P 2: Balance turning off automatically after 60 minutes
GAB/GAS/FAB-BA-e-0720 11