Appendix A: Resetting Factory Default Settings - Planet ICA-HM830W User Manual

2 mega-pixel wireless fish-eye ip camera

Hide thumbs Also See for ICA-HM830W:

Table of Contents

Appendix A: Resetting Factory Default

Settings

There is a button hidden in the pinhole near the Mic. This button is used to restore all the factory

default settings. Sometimes restarting the Internet Camera will make the system back to a normal

state. However, if the system still got problems after restart, user can restore the factory default

settings and install it again.

Restoring the Internet Camera:

1. Unplug the power jack to turn off the power of ICA-HM830W.

2. Insert a pin into the reset hold as indicated in orange as shown in the figure below. Keep the

button pressed until instructed to release.

3. Plug in the power jack to turn on the ICA-HM830W. In about 20 seconds the LED indicator will

start to flash.

4. Release the button. (Remove the pin from the reset hold)

5. The ICA-HM830W can now return to factory default. Have access to the Internet Camera by

changing IP address from the default 192.168.0.20.

Restoring the factory default setting will lose all the previous settings including IP

address forever. User needs to run the PLANET IPInstaller program to search the

unit and configure it to let the Internet Camera work properly again.

2 Mega-Pixel Wireless Fish-Eye IP Camera

ICA-HM830W

Table of Contents