Appendix A: Reset Factory Default Settings - Planet Wired / Wireless IR IP Camera ICA-108W User Manual

Appendix A: Reset Factory Default Settings

There is a button hidden in the pinhole near to the DC power connector. This button is used to
restore the factory default settings. Sometimes restarting the ICA-108/108W will make the system
back to a normal state. If the system still got problems after reset, user can restore the factory
default settings and install it again.
Restore the ICA-108/108W:
1. Insert the paper clip or other tool and press and hold the button down continuously.
2. Wait at least 3 seconds and release the button. Then the ICA-108/108W has been
restored to factory default settings and reboot again.
Note: Restoring the factory default setting will lose the all previous settings included IP
address forever. User will need to run the IPWizard program to search the device and
configure it to let the device work properly again.
Reset to Factory Default
66