Appendix A: Restore Factory Default Settings - Planet ICA-106 User Manual

Planet technology ir ip camera user's manual ica-106

Hide thumbs Also See for ICA-106:

Table of Contents

Appendix A: Restore Factory

Default Settings

There is a switch hidden in the pinhole under the bottom of Network Camera. It is used

to restore the factory default settings. While the Network Camera got problem,

sometimes, restarting the Network Camera will make the system back to a normal state.

In case the system still got problems after reset, user can restore the factory default

settings and install it again.

Restore the Network Camera:

1. Power off the Network Camera.

2. Insert the paper clip or other tool and press and hold the button down

continuously.

3. Power on the Network Camera again.

4. Wait at least 10 seconds and release the tool. Then the Network Camera has

been restored to default settings.

5. Reconfigure the Network Camera

Note: Restoring the factory default setting will lose the all previous settings forever. User

needs to run the IP Finder program to search the Network Camera and configure it to let

the Network Camera work properly again.

45/60

Factory

Default Reset

Table of Contents