Using The Electric Thermostat; Using The Thermostat With Switch In Series - Bertazzoni W906MFE Series Installation, Maintenance And Use Instructions

(for cookers equipped with ignition trough knob) or press the ignition button marked with a star and release it as soon as
the burner has ignited.
- Burner ignition equipped with safety device (thermocouple)(fig.22): Turn the knob anticlockwise that corresponds
to the burner selected, setting it to the MAXIMUM position at the etched star (large flame Fig. 21), press the knob and
activate one of the above-mentioned ignition devices. Once ignited, keep pressing the knob for about 10 seconds to
allow the flame to heat the thermocouple. If the burner goes out after releasing the knob, repeat the entire operation.
Note: It is recommended not to try to ignite a burner if the relative flame cap is not in the correct position.
If the flame does not light after the first attempt, wait 5 minutes for the gas to dissipate before attempting to re-light the
burner.
Tips for using burners correctly:
- Use suitable pots for each burner (see tab. 4 and Fig. 23).
- When the liquid is boiling, turn the knob to the MINIMUM position (small flame Fig. 21).
- Always use pots with a cover.
TABLE N°5
Semi-rapid
WARNING: If the power is cut off, the burners can be lit with matches. When cooking foods with oil and fat,
which are very flammable, the user should not leave the appliance unattended. If the appliance is equipped with
a glass cover, such a cover may break when heated. Turn off all burners before lowering the cover. Do not use
sprays near the appliance when it is being used. When using the burners, make sure that the handles of the pots
are correctly positioned. Keep children away from the appliance. If equipped with a cover, before being closed,
any food deposits should be cleaned off the built-in surface.
NOTE: The use of a gas cooking appliance produces heat and humidity in the room where it is installed.
Therefore, proper aeration in the room is needed while ensuring that natural ventilation openings remain
unobstructed (Fig.2) and activating the mechanical aeration device/exhaust hood or electric fan (Fig. 3 and Fig.
4). Intensive and continuous use of the appliance may require additional aeration, for example by opening a
window, or more efficient aeration by increasing the power of the mechanical exhauster, if installed.
The thermostat supplied with the relative models maintains a constant temperature inside the oven at a specific
temperature setting ranging from 50°C to 250°C.(fig.26)
Turn the knob clockwise and align the selected temperature indicated on the ring with the index etched on the control
panel. Thermostat operation is indicated by an orange light which will turn off when the temperature inside the oven is
10°C greater than the temperature setting, and will turn on when the oven is 10°C less than the temperature setting. The
thermostat can control the oven elements only if the relative switch is in one of the possible oven element operating
modes: if the switch is in position 0, the thermostat has not effect on the oven elements, which remain off.
USING THE THERMOSTAT WITH SWITCH IN SERIES (Right oven)
(COOKERS WITH A SINGLE-CONTROL CONVENTIONAL ELECTRIC OVEN)
The electric oven is controlled by an electric thermostat combined with a switch used to turn on the elements. The
electric oven can be combined with an electric grill. The oven is heated by 2 elements: one on the top and one on the
bottom. Turning the knob clockwise (fig.27) in the first position we have the single operation of the oven light
Turns on the bottom element and the top external elements while the thermostat is used to set the temperature ranging
from 50°C to 250°C. It can be adjusted using the scale indicated on the ring around the knob. An orange light turns off
indicating that the temperature setting has been reached. Therefore, it is normal for this light to turn on and off while the
oven is working. There are 3 fixed position beyond the 250°C setting:
- the symbol indicates the only the bottom element (900W) has been turned on;
- the symbol indicates that only the top external element (600W) has been turned on;
- the symbol indicates that only the grill element (900W) has been turned on;
In these positions the temperature is not controlled by the thermostat.
BURNER PAN DIAMETER recommended (cm)
Auxiliary
Rapid
Dual
USING THE ELECTRIC THERMOSTAT (left oven)
12-14
14-26
18-26
22-26
8
ATTENTION: Use pots with a flat
bottom
.