Introduction; How To Use This Manual; Equipment Identification; Receipt Of Equipment - Thermal Arc ARCMASTER 200 TS Service Manual

2

INTRODUCTION

1

How To Use This Manual

This Service Manual applies to just specification or
part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these
headings. These special annotations are easily
recognized as follows.
WARNING
A WARNING gives information regarding possible
personal injury.
CAUTION
A CAUTION refers to possible equipment damage.
NOTE
A NOTE offers helpful information concerning cer-
tain operating procedures.
Additional copies of this manual may be purchased
by contacting Thermal Arc at the address and
phone number in your area listed in the inside
back cover of this manual. Include the manual
number and equipment identification numbers.
Electronic copies of this manual can also be down-
loaded at no charge in Acrobat PDF format by
going to the Thermal Arc web site listed below and
clicking on the Literature Library link:
http://www.thermalarc.com
2

Equipment Identification

The unit's identification number (specification or
part number), model, and serial number usually
appear on a nameplate attached to the control
panel. In some cases, the nameplate may be
attached to the rear panel. Equipment which does
not have a control panel such as gun and cable
assemblies is identified only by the specification or
part number printed on the shipping container.
Record these numbers on the bottom of page i for
future reference.
3

Receipt Of Equipment

INTRODUCTION
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to ship-
ping. If there is any damage, notify the carrier
immediately to file a claim. Furnish complete infor-
mation concerning damage claims or shipping
errors to the location in your area listed in the
inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
uncrating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
2 – 1