Figure 2-15. 110W Radio Mounting Into Quick Release Trunnion - Motorola ASTRO XTL 2500 Installation Manual

Standard Configurations: Radio Mounting
2.2.2.1.1 110W Radios Only
1. After selecting the mounting location, use the trunnion mounting bracket as a template and
mark the positions of the holes on the mounting surface.
2. Center-punch the spots you have marked and realign the trunnion in position.
3. Secure the trunnion mounting bracket with the five self-drilling screws provided (see
11 and Figure
4. A. Quick release trunnion (HLN6909_): See
radio and are needed for proper radio installation. After the trunnion has been mounted in the
vehicle using the screws provided, insert the rear of the radio into the rear catches of the
trunnion at an angle of approximately 20º, and push it into the trunnion until it contacts a hard
stop. With the handle rotated toward the front of the radio, rotate the radio down into the
horizontal position. If the radio is not completely inserted, it cannot be rotated to this position.
With the key in the unlocked position (3 and 9 o'clock), rotate the handle towards the back of
the radio to secure it. Using the keys provided, lock the handle in place and remove the keys.
The handle must be locked in place with the keys removed for proper installation. The keys
can only be removed from the lock when it is in the locked position.

Figure 2-15. 110W Radio Mounting into Quick Release Trunnion

HLN6923A
2-12).
Figure 2-15. Two keys were packaged with the
2-9
Figure 2-
October 12, 2005