Surround Sound Speaker Setup(Dvd-909 Only) - Samsung DVD-909 Service Manual

DVD-YURO909/709 11/4/95 10:01 AM
S
urround Sound Speaker Setup (DVD-909 only)
The DVD-909 has a Speaker Setup feature that allows you to customize your surround sound setup.
Only when the DVD disc is played or the disc isn't loaded, this feature will be activated.
1. Press the SETUP button in play or stop mode.
1.
2.
Press the UP/DOWN button to select AUDIO
2.
OPTIONS. Then press the ENTER button.
3. Use the UP/DOWN button to select SPEAKER
3.
SETUP. Then press the ENTER button.
Speaker Mode Channel
(Front L)
Balance
(Center)
OdB
TEST
Channel
Speaker Mode
Balance
(Surround L)
(Surround L)
OdB
SPEAKER MODE
You can set a mode in the system that's currently used.
Initially it is set as follows:
• Front speaker (L/R) : Found (Large)
• Center speaker : Not found
• Subwoofer : Not found
• Surround speaker (L/R) : Not found
DELAY TIME
You can customize the sound to conform to the acoustics of
your room by adding a delay effect to the sound of the Center
Speaker and Surround Speaker. Initially it is set as "Oms (mil-
liseconds)".
TEST
It sends test signals memorized in the system to each speaker
except Subwoofer.
CHANNEL BALANCE
Adjust the output level of a speaker by using test signals that
are memorized in the system. Initially it is set as "OdB".
How to make the SETUP MENU disappear or
return to menu screen during set up.
Press RETURN button.
Page 37
SPEAKER SETUP
Speaker Mode
Speaker Mode
Delay Time
(Center) (Front R)
(Center)
Oms
Channel
Speaker Mode
Balance
(Subwoofer)
(Subwoofer)
OdB
Delay Time
Channel
Speaker Mode
(Surround L/R)
Balance
(Surround R)
Oms
(Surround R)
OdB
D D V V D D
D D V V D D
4. Use the UP/DOWN or LEFT/RIGHT button to
4.
select the desired item. Then press the ENTER
button.
5.
Use the UP/DOWN button to select OPTION.
5.
Then press the ENTER button.
Setting up SPEAKER MODE
• If you have connected the system to a speaker with low fre-
quencies of 100Hz or below, select 'Found(Large)'.
• If you have connected the system to a speaker without low
frequencies of 100Hz or below, select 'Found(Small)'. But if
you don't connect to a subwoofer, always select
'Found(Large)' for Front Speakers(L/R).
• When you don't connect to speaker, select 'Not found'.
Setting up DELAY TIME
• When 5.1CH Surround Sound is played, you can enjoy the
best sound if the distance between you and each speaker is
the same. You can set Delay Time in the Center/Surround
Speaker to customize the sound to the acoustic of your
room.
Ideal CENTER SPEAKER position
Ideal SURROUND SPEAKER position
• Setting SURROUND SPEAKERS
If the distance of Df is equal to the distance of Ds in the
above, set the mode as Oms. Otherwise, change the setting
according to the table below.
(B) = Df - Ds
Distance of (B)(cm) Setting(ms)
200
400
600
Setting up TEST
The test output signals come clockwise starting from the Front
Speaker(L). Adjust Channel Balance to match to the volume of
test signals memorized in the system.
FRONT(L) CENTER
SURROUND(R)
• The subwoofer test output signal is lower than the other
N
speakers.
O
T
• The MPEG Multichannel logo is a trademark registered by
E
PHILIPS Corporation.
• Setting CENTER
SPEAKER
If the distance of Dc is
equal to or longer than
• Arrange all
the distance of Df in the
speakers
within circle.
left figure, set the mode
as Oms. Otherwise,
change the setting
according to the table
below.
(A) = Df - Dc
Distance of (A)(cm) Setting(ms)
50 1.3
100 2.6
150 3.9
200 5.3
5.3
10.6
15.9
FRONT(R) SUBWOOFER
SURROUND(L)
37