JVC HR-J271MS Instructions Manual page 23

1 2
4 5
8
7
0
START+/–
1
3
2
6
9
4
PR +/–
OK
PUSH JOG
When programmes overlap
each other
If "PROGRAM OVERLAPPED" appears, you have another
programme overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
PROGRAM OVERLAPPED
Example: Programme 1 (you have just made) and Programme 4
overlap each other.
CONFIRM THE OVERLAP-
PING PROGRAMMES
1
Overlapping programmes blink on the TV screen.
SELECT THE PROGRAMME
TO MODIFY
2
Press PUSH JOG %fi, then press OK or PUSH JOG .
You can only select one of the overlapping
programmes.
NOTE:
If you do not mind this overlap, press PROG to finish
the timer programme setting. The programme with the
lower programme number will be recorded and the
other one will not be recorded correctly. If no changes
are made for approximately 1 minute, the recorder will
return to the normal screen.
CANCEL OR CHANGE
PROGRAMME SETTING
3
To cancel a programme, press
screen you do not want is shown. "PROGRAM
COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen appears.
a programme, press the appropriate button: START+/-,
STOP +/-, DATE+/-, PR+/- and/or SP/LP/EP (
when the Programme screen on which you want to
make changes is shown, then press OK. "PROGRAM
COMPLETED" appears on the TV screen for about 5
seconds, then the normal screen appears.
NOTE:
If the overlap is not yet solved, or another overlap
occurs with the timer programme setting after making
the last correction on a programme, the conflicting
programmes will be shown on the Programme Check
screen again. Repeat the above steps again until the
overlap is solved.
23
EN
PR START STOP CH DATE
1 8:00 10:00 3 24.04
2 10:00 10:45 2 TUE
3 11:30 13:00 1 25.04
4 9:00 10:00 92 DAILY
5
6
7
8
[5/∞] =
[PROG] : EXIT
when the Programme
To change
)