D-Link DKVM-IP8 User Manual page 8

DKVM-IP8 Setup Tool
If this initial configuration does not meet your local requirements, use the setup tool to
change the configurations to your needs. The setup tool PSetup can be found on the
CD ROM delivered with this package. You can follow the procedures described below.
■
DHCP
If you have installed the DKVM-IP8 unit on a network that enables DHCP, you can
use the PSetup to find out the DKVM-IP8 unit's IP.
(1) Plug Ethernet cable to DKVM-IP8 unit. DKVM-IP8 will get an IP via DHCP.
(2) Using PSetup (run PSetup.exe) to look for DKVM-IP8.
a. Select MAC address which label on bottom of DKVM-IP8 unit
b. Click Query Device
■
Setup the fixed IP
a. Setup "IP auto configuration" as "None" ; setup IP address and Subnet mask
b. Enter Super user login and password for Authentication (default : super/pass)
c. Click Setup Device. If super login was authenticated, it'll show "Successfully
configured device". Otherwise it'll show "Permission Denied".
8 / 104
DKVM-IP8 User Manual