D-Link DKVM-IP8 User Manual page 75

Changing the network settings of the DKVM-IP8 might result in losing
connection to it. In case you change the settings remotely make sure that all
the values are correct and you still have an option to access the DKVM-IP8.
IP auto configuration
With this option you can control if the DKVM-IP8 should fetch its network settings
from a DHCP or BOOTP server. For DHCP, select "dhcp" , and for BOOTP select
"bootp" accordingly. If you choose "none" then IP auto configuration is disabled.
Preferred host name
Preferred host name to request from DHCP server. Whether the DHCP server
takes the DKVM-IP8 suggestion into account or not depends on the server
configuration.
IP address
IP address in the usual dot notation.
Subnet Mask
The net mask of the local network.
Gateway IP address
In case the DKVM-IP8 should be accessible from networks other than the local one,
this IP address must be set to the local network router's IP address.
Primary DNS Server IP Address
IP address of the primary Domain Name Server in dot notation. This option may be
left empty, however the DKVM-IP8 will not be able to perform name resolution.
Secondary DNS Server IP Address
IP address of the secondary Domain Name Server in dot notation. It will be used in
case the Primary DNS Server cannot be contacted.
Remote Console And HTTPS port
Port number at which the DKVM-IP8's Remote Console server and HTTPS server
are listening. If left empty the default value will be used.
HTTP port
Port number at which the DKVM-IP8's HTTP server is listening. If left empty the
default value will be used.
Telnet port
Port number at which the DKVM-IP8's Telnet server is listening. If left empty the
default value will be used.
Warning
75 / 104
DKVM-IP8 User Manual