Russell Hobbs RHEM20L Instruction Manual page 15

2. Turn the control dial to adjust the defrost cycle time to 5 minutes.
3. Press MICROWAVE once.
4. Now turn the control dial to choose 80% microwave power. P80 will show on the LCD
display.
5. Press START/ +30SEC/ CONFIRM to confirm this selection.
6. Turn the control dial to adjust the cooking cycle time to 7 minutes.
7. Finish your multi-stage selection by pressing the START/ +30SEC/ CONFIRM button to
start cooking.
PRESET (DELAY START) FUNCTION
Ensure that you have set the digital clock first. (Check ―Setting the Digital Clock‖)
1.
2. Start by inputting the desired cooking program. Remember that two multi-stages can be
selected at most. Note that defrosting should not be set in the preset function.
Example: if you want to cook with 80% microwave power for 7 minutes.
3. Press MICROWAVE once.
4. Turn the control dial to choose 80% microwave power. P80 will show on the display.
5. Press START/ +30SEC/ CONFIRM to confirm this selection.
6. Turn the control dial to adjust the cooking time to 7 minutes.
7. After completion of the above steps, please do not press START/ +30SEC/ CONFIRM
button. Proceed as follows:
 Press CLOCK/ PRE-SET and the minute figure will flash on the display.
 Turn the control dial to adjust the minute figure. The input time should be within 0—59
minutes.
 Now press the CLOCK/ PRE-SET button and the hour figure will flash.
 Turn the control dial to adjust the hour figure. Here the input time should be between
0—23 hours.
 Press START/ +30SEC/ CONFIRM to finish this setting.
 The alert tone will ring twice when the cooking start time arrives and the cooking cycle
will start automatically.
Note: The digital clock must be set first. If it is not set, then the preset (delay start) function will
not work.
":"
15
will show.