Xtreme NXRT 1000VA User & Installation Manual

Online ups
Hide thumbs Also See for NXRT 1000VA:

Advertisement

Quick Links

NXRT Online UPS
1000VA, 1500VA, 2000VA, 3000VA Models
User & Installation Manual
www.xpcc.com
| © 2014 Xtreme Power Conversion Corporation. All rights reserved. (Rev 12/18/14)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NXRT 1000VA and is the answer not in the manual?

Questions and answers

Summary of Contents for Xtreme NXRT 1000VA

  • Page 1 NXRT Online UPS 1000VA, 1500VA, 2000VA, 3000VA Models User & Installation Manual www.xpcc.com | © 2014 Xtreme Power Conversion Corporation. All rights reserved. (Rev 12/18/14)
  • Page 2: Table Of Contents

    Turning Off the Ups When Connected to an AC Source..............25 Starting the UPS From a DC Source (Cold Start)................25 Turning Off the UPS When in DC Mode..................25 Self Test Operation.........................25 Audible Alarm Silence in DC Mode or Fault Mode.................26 Xtreme Power Conversion Corporation Page 2...
  • Page 3 LCD Fault Codes..................30 Specifications.....................31 Shipping List ....................32 Obtaining Service..................33 Xtreme Power Conversion Limited Warranty..........34 Xtreme Power Conversion Load Protection Policy........35 Appendix A: Extended Battery Pack User Guide.........38 Estimated Run Time for UPS with Extended Battery Packs............38 Extended Battery Pack Configuration.....................39 LED Description..........................40 Extended Battery Pack Operation....................40...
  • Page 4 UPS, please refer to the Troubleshooting section in this manual to correct the problem. If the problem is not corrected, please collect information so that the Technical Support personnel can more effectively assist you. Xtreme Power Conversion Corporation Page 4...
  • Page 5: Emc Statements - Fcc Part 15

    WARNING! (Fuses): To reduce the risk of fire, replace only with the same type and size of fuse. WARNING! Unit intended for installation in a controlled environment. CAUTION! Do not dispose of batteries in a fire, the battery may explode. Xtreme Power Conversion Corporation Page 5...
  • Page 6 Except for replacing the batteries, all servicing on this equipment must be carried out by qualified service personnel. Before conducting any maintenance, repair, or shipment, first ensure that everything is turned off completely and disconnected. For additional safety instructions, please use the Safety Manual as a reference. Xtreme Power Conversion Corporation Page 6...
  • Page 7: Special Symbols

    RJ45 RECEPTACLE – The receptacle provides network interface connections and telephone or telecommu- nications equipment should not be plugged into it. Please do not discard of the UPS or the UPS batteries as the UPS may have valve-regulated lead-acid bat- teries. Please recycle batteries appropriately. Xtreme Power Conversion Corporation Page 7...
  • Page 8: Introduction

    • DC power is converted to AC in the inverter, passing it on to the load. • Power is maintained from the battery during a power failure. • The converter increases voltage appropriately for the inverter. Xtreme Power Conversion Corporation Page 8...
  • Page 9: Diagnostic Tests

    When the UPS is started, a diagnostic test is automatically executed, checking the electronics and batteries, report- ing any problems on the LCD display. A diagnostic test can also be performed manually from the front panel at any time. Xtreme Power Conversion Corporation Page 9...
  • Page 10: System Configuration

    Extended Battery Packs • NXRT-EBP1 for 1000 • NXRT-EBP2 for 1500 • NXRT-EBP3 for 2000/3000 Connectivity Options –SNMP/WEB card Xtreme Power Distribution Units (XPDU) See the Specification section of this manual for additional model information. Xtreme Power Conversion Corporation Page 10...
  • Page 11 NXRT User’s Manual Uninterruptible Power Supply Xtreme Power Conversion Corporation Page 11...
  • Page 12: Led Description

    Line Four This indicates the status of the UPS. • ON LINE = utility mode • ON BATT = battery mode • ON BPS = bypass mode • UPS OFF = standby mode Xtreme Power Conversion Corporation Page 12...
  • Page 13: Rs-232 Standard Interface

    Since the REPO shuts down the equipment immediately, orderly shutdown proce- dures are not followed by any power management software. The UPS will have to be manually restarted in order to regain power to the outlets on the UPS. Xtreme Power Conversion Corporation Page 13...
  • Page 14: Determining The Power Requirements Of Your Equipment

    The instructions in this manual explain how to install the UPS safely. Not acknowledging such electrical hazards may be fatal – keep this manual for future reference. Xtreme Power Conversion Corporation Page 14...
  • Page 15: Environment

    • Space and ventilation requirements must be met. Ensure there is 100mm behind and 50mm on the sides of the UPS for proper ventilation. • Ensure that the front of the UPS remains clear for user operation. Installation Standard brackets Xtreme Power Conversion Corporation Page 15...
  • Page 16 NXRT User’s Manual Uninterruptible Power Supply 19” Cabinet Ear Installation Xtreme Power Conversion Corporation Page 16...
  • Page 17 NXRT User’s Manual Uninterruptible Power Supply Vertical Installation Steps Xtreme Power Conversion Corporation Page 17...
  • Page 18 NXRT User’s Manual Uninterruptible Power Supply Wall-mounted Installation Steps Xtreme Power Conversion Corporation Page 18...
  • Page 19 NXRT User’s Manual Uninterruptible Power Supply 19” Rack mount using 5 in 1 bracket Xtreme Power Conversion Corporation Page 19...
  • Page 20: Rack-Mount Installation Steps

    NXRT User’s Manual Uninterruptible Power Supply Rack-Mount Installation Steps UPS Rail Installation Instructions to 19” Cabinet Step 1 Step 2 Step 3 Xtreme Power Conversion Corporation Page 20...
  • Page 21 NXRT User’s Manual Uninterruptible Power Supply Step 4 Step 5 Step 6 Xtreme Power Conversion Corporation Page 21...
  • Page 22 Uninterruptible Power Supply Step 7 Note: Any external Battery Packs must be installed next to or under the UPS. Please refer to Appendix A: Battery Pack User Guide for more information when installing these. Xtreme Power Conversion Corporation Page 22...
  • Page 23 If it does not, click on Settings up on the UPSilon toolbar, then select a dif- ferent Comport until communication is established. • Click on “Manual” in the UPSILON toolbar for further software configuration. • NOTE: PLEASE VERIFY AUTOMATIC SHUTDOWN TIME PARAMETERS IN THE SETTINGS SECTION FOR Xtreme Power Conversion Corporation Page 23...
  • Page 24 8. After charging is complete, connect the loads to the UPS while monitoring the load levels via the UPS LCD or via the software. • Do not connect any devices that have the possibility of overloading the UPS. Refer to the Troubleshooting section and/or Technical Support with any problems during setup. Xtreme Power Conversion Corporation Page 24...
  • Page 25: User's Operations

    • Press and hold the “Function” button for a minimum of two seconds. • The self-test will last for 10 seconds, during this time the LED’s will be lit in a sequential, repeating fashion. Xtreme Power Conversion Corporation Page 25...
  • Page 26: Audible Alarm Silence In Dc Mode Or Fault Mode

    “Function” Button for a minimum of two (2) seconds to disable the audible alarm. • When the UPS is in Fault Mode, the audible alarm will continuously sound. Press and hold the “Function” Button for a minimum of two (2) seconds to disable the audible alarm. Xtreme Power Conversion Corporation Page 26...
  • Page 27: Batteries

    (applicable to a UPS and a remote battery supply not having a grounded circuit). Slide the plastic cover to the right. Remover the M5x10 screws on the right side. Xtreme Power Conversion Corporation Page 27...
  • Page 28 Uninterruptible Power Supply Remove plastic front cover Locate the battery tray on the right front side of the UPS Remove (4) M4x6 screws marked with letter A. Remove the battery tray from the UPS. Xtreme Power Conversion Corporation Page 28...
  • Page 29: Troubleshooting

    Major fault detection by Type of fault and fault Constant beep take appropriate action, If the UPS code displayed on LCD. problem does not resolve contact supplier for service and provide error code(s) Xtreme Power Conversion Corporation Page 29...
  • Page 30: Lcd Fault Codes

    NXRT User’s Manual Uninterruptible Power Supply LCD Fault Codes BYP MODE LINE MODE BAT MODE BAT TEST MODE BUS FAULT 05–25 01–21 40–41 INV FAULT 61–63 OVERHEAT OP SHORT OVERLOAD FAN FAULT CHARGE FAULT BAT OVER Xtreme Power Conversion Corporation Page 30...
  • Page 31: Specifications

    RS-232, EPO, intelligent slot for optional cards (Web/SNMP, Relay/dry contact) INCLUDED IN BOX UPSILON CD, horizontal brackets, 5:1 brackets, user manual, 6ft DB9 cable AVAILABLE OPTIONS 5 year extended warranty, bypass distribution (XBDM), power distribution (XPDU) *Depending on load level Xtreme Power Conversion Corporation Page 31...
  • Page 32: Shipping List

    1. (1) UPS 2. (1) User’s and Installation Manual 3. (1) 6 ft RS232 cable 4. (1) UPSILON CD (monitoring software) 5. (2) sets of 5-in-1 mounting brackets 6. (1) set of horizontal mounting brackets Xtreme Power Conversion Corporation Page 32...
  • Page 33: Obtaining Service

    2. Verify there are no circuit breakers tripped. 3. Call your dealer for assistance. If you cannot reach your dealer, or if they cannot resolve the problem, call Xtreme Power Conversion Corp Technical Support at 800.582.4524. Technical support inquiries can also be made at support@xpcc.com.
  • Page 34: Xtreme Power Conversion Limited Warranty

    Any technical advice furnished by XPC Corporation or a XPC Corpora- tion authorized representative before or after delivery with regard to the use or application of Xtreme Power Con- version equipment is furnished on the basis that it represents XPC Corporations best judgment under the situation and circumstances, but it is used at the recipient’s sole risk.
  • Page 35: Xtreme Power Conversion Load Protection Policy

    NXRT User’s Manual Uninterruptible Power Supply Xtreme Power Conversion Load Protection Policy THIS POLICY IS NOT A WARRANTY. REFER TO THE XPC CORPORATION, INC. LIMITED WARRANTY FOR INFORMATION CONCERNING THE WARRANTY FOR YOUR XPC PRODUCT. THE LIMITATIONS AND CONDITIONS CONTAINED IN THIS POLICY DO NOT AFFECT THE TERMS OF THE XPC LIMITED WARRANTY.
  • Page 36 Purchaser and the name of the power utility supplier for the location of the Connected Equipment. XPC will forward to the Purchaser a Load Protection Policy claims form, which Xtreme Power Conversion Corporation Page 36...
  • Page 37 No employee of XPC or any other party is authorized to make any representations beyond those made in this agreement con- cerning the Load Protection Policy. XPC Corporation 230 Yuma Street Denver, CO 80223 1.800.582.4524 Xtreme Power Conversion Corporation Page 37...
  • Page 38: Appendix A: Extended Battery Pack User Guide

    NXRT-3000 3000 2100 Note: for estimated run times using more than 5 EBP’s, contact Xtreme Power Conversion at support@xpcc.com. CAUTION: It is very critical to connect the correct voltage EBP with the UPS intended. EBP1 is for NXRT-1000 EBP2 is for NXRT-1500...
  • Page 39: Extended Battery Pack Configuration

    NXRT User’s Manual Uninterruptible Power Supply Extended Battery Pack Configuration Xtreme Power Conversion Corporation Page 39...
  • Page 40: Led Description

    1. The DC Circuit Breaker on the rear of the EBP connects and disconnects the DC bus voltage from the EBP to the UPS. The DC Circuit Breaker will also trip to the OFF position in the event of an over-current condi- tion in the EBP. Xtreme Power Conversion Corporation Page 40...
  • Page 41 UPS in the appropriately labeled connector, or for connecting the first EBP to the UPS. 3. The AC input cord is for connecting AC utility to operate the Charger contained in every third EBP. Xtreme Power Conversion Corporation Page 41...
  • Page 42: Extended Battery Pack Installation

    8. If the EBP’s are plugged into an AC source and properly installed, the internal batteries will be charged when acceptable voltage is present. EBP’s must be charged for a minimum of 6 hours for full battery time. Xtreme Power Conversion Corporation Page 42...
  • Page 43: Extended Battery Pack Q & A

    The charger on each EBP functions independently from the others. One EBP charger may be charging while another one might be at 100% and the charger turned off. This is normal operation of the EBP. Xtreme Power Conversion Corporation Page 43...

This manual is also suitable for:

Nxrt 1500vaNxrt 2000vaNxrt 3000va

Table of Contents