Safety Information - Martin Professional Stagebar 54 User Manual

Safety Information

The following symbols are used to identify important safety information on the product and in this manual:
Warning!
Safety hazard.
Risk of severe
injury or death.
Warning! Class 2M LED product. Do not look into the beam from a distance
of less than 40 cm (16 inches). Do not stare into the beam for extended
periods at a short distance. Do not view the beam directly with optical
instruments.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire hazards, electric shock and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture. If you have questions about how to
operate the fixture safely, please contact your Martin™ dealer or call the Martin™ 24-hour service hotline at
+45 70 200 201.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Shut down power to the entire installation at the building's main power distribution board and lock out
power (by removing the fuse for example) before carrying out any installation or maintenance work.
• Disconnect the fixture from AC power before removing or installing any cover or part and when not in use.
• Always ground (earth) the fixture electrically.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Connect this fixture to AC power either using the supplied power cable or via 3-conductor cable that is
rated minimum 20 amp, hard usage. Suitable cable types include ST, SJT, STW, SEO, SEOW and STO.
• The voltage and frequency at the power outlet are the same as the voltage and frequency applied to the
power inlet. Only connect devices to the power outlet that accept this voltage and frequency.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Do not use the fixture if the power cable or power plug are in any way damaged, defective or wet, or if
they show signs of overheating.
Read the safety precautions in this section before
installing, powering, operating or servicing this
Warning!
LED light
emission. Risk
of eye injury.
WARNING!
product.
Warning! Warning!
Refer to Hazardous
manual before voltage. Risk of
installing, lethal or severe
powering or electric shock.
servicing.
Warning!
Fire hazard.