Introduction And Safety; Safety Precautions; About This Manual - Martin Professional Exterior 600 User Manual

Table of Contents

Advertisement

s e c t i o n 1
I N T R O D U C T I O N A N D S A F E T Y
Thank you for selecting the Martin Exterior 600. This automated luminaire combines a range of architectural lighting
effects with extremely bright output in an attractive aluminum housing designed for permanent outdoor installation.
S a f e t y p r e c a u t i o n s
The Exterior 600 is not for domestic use. It presents potential risks due to electric shock, heat and ultraviolet radia-
tion burns, lamp explosion, falls, high-intensity light, and fire. A thorough understanding of the dangers, genuine con-
cern for safety, and attention to detail are required to prevent accidents. Read this manual before powering or installing
the fixture, follow the safety precautions listed below and observe the warnings in this manual and printed on the fix-
ture, and always double check the safety conditions. If you have questions about how to operate the Exterior 600,
please contact your Martin dealer for assistance.
ALWAYS disconnect the fixture from AC power and allow it to cool for 20 minutes before:
- Changing the transformer or ballast settings
- Installing or removing the lamp
- Checking or replacing fuses
- Removing any cover or part from the fixture
ALWAYS keep combustible materials at least 1 meter (39 inches) away from the fixture. Keep flammable
materials well away from the fixture.
For protection against dangerous electric shock, ALWAYS ground (earth) the fixture electrically. Use only
a source of AC power that complies with local building and electrical codes.
Replace defective or worn out lamps immediately. Replace working lamps before usage exceeds the maxi-
mum service life.
ALWAYS use at least one fastener in each of the 4 curved mounting slots in the base.
ALWAYS refer any service operation not described in this manual to a qualified technician.
NEVER illuminate surfaces within 1 meter (39 inches) of the fixture.
NEVER place filters or other materials over the lens or front glass plate.
NEVER operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
NEVER stare directly into the light.
NEVER operate the fixture without all lenses and covers installed: an unshielded lamp emits dangerous
UV radiation that can cause burns and eye damage, and it can explode without warning.
NEVER modify the fixture or install other than genuine Martin accessories.
A b o u t t h i s m a n u a l
This user manual covers the Exterior 600 with version 1.5 software. The latest Exterior 600 news, documentation, and
software is available from the Martin Professional web site at http://www.martin.dk.
4
Exterior 600

Advertisement

Table of Contents
loading

Table of Contents