Table of Contents
Advertisement
PTZ
Here you can set PTZ movement when alarm occurs. Such as go
Activation
to preset X. See Figure 5-51.
Video Matrix
This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-channel tour function. System takes "first come and first
serve" principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-52.
After analysis video, system can generate a video loss alarm when the detected moving
signal reached the sensitivity you set here.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest
setups, please refer to chapter 5.8.3.1.1 motion detect for detailed information.
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-53.
After analysis video, system can generate a tampering alarm when the detected moving
signal reached the sensitivity you set here.
For detailed setups, please refer to chapter 5.8.3.1.1 motion detect for detailed
information.
Figure 5-52
193
Advertisement
Table of Contents
