Safety Section; Safety Messages; General Hazard Information - Perkins 1103 Operation And Maintenance Manual

SEBU7833-01
Safety Section
i02206606
Safety Messages
There may be several specific warning signs on
an engine. The exact location of the hazards and
the description of the hazards are reviewed in this
section. Please become familiar with all warning
signs.
Ensure that all of the warning signs are legible. Clean
the warning signs or replace the warning signs if
the words cannot be read or if the pictures are not
visible. When the warning signs are cleaned, use a
cloth, water, and soap. Do not use solvent, gasoline,
or other harsh chemicals to clean the warning signs.
Solvents, gasoline , or harsh chemicals could loosen
the adhesive that secures the warning signs. The
warning signs that are loosened could drop off of
the engine.
Replace any damaged warning signs or missing
warning signs. If a warning sign is attached to a part
of the engine that is replaced, install a new warning
sign on the replacement part. Perkins dealers or
Perkins distributors can provide new warning signs.
Do not work on the engine and do not operate the
engine unless the instructions and warnings in the
Operation and Maintenance Manual are understood.
Correct care is your responsibility. Failure to follow
the instructions or failure to heed the warnings could
result in injury or in death.
The warning labels that may be found on the engine
are illustrated and described.
Ether
5
Safety Section
Safety Messages
The warning label for ether is located on the top, the
front, the rear, or the side of the engine .
A.
WARNING
g00640926
Never spray Ether starting aids into the air intet.
i02203039
General Hazard Information
Illustration 1
g00104545
Attach a "Do Not Operate" warning tag or a similar
warning tag to the start switch or to the controls
before you service the equipment or before you
repair the equipment.