E Xternal Wireless Devices - JabloCom EYE-02 User Manual

E
XTERNAL WIRELESS DEVICES
Camera EYE-02 has a built
range of professional security wireless devices produced by Jablotron Alarms (www.jablotron.com).
This is very simple how to extend your camera function to provide additional services as: heating
control by mobile phone or panic button function for elder or disabled people.
Look at the table on the last page of this manual to get short introduction about available types of
wireless devices.
O
UTDOOR INSTALLATION
Although the EYE-02 camera housing guarantees a basic water resistance and passes the testing, it is
strictly recommended to use an additional plastic shielding when mounted outdoor.
Please visit the www.jablocom.com web page to download the detail application notes about
outdoor installation or usage with a solar power panel.
M
AINTENANCE
The device doesn't require any special maintenance.
The camera basic function should be regularly tested by TEST button at least once a month.
To check correct detector functioning, it is recommended to trigger an intentional alarm by
activation of different detectors from time to time.
Once a year the battery capacity should be checked – see Battery information chapter.
T
ROUBLESHOOTING
JABLOCOM is improving the EYE-02 camera software as well as the JabloTool software continuously.
If you have any trouble please visit www.jablocom.com to find the latest version of camera firmware,
supporting software and
Problem / Error message
RED light on the front camera panel
blinks
Camera doesn't react to remote
control button
If you find an incorrect camera behavior, please try to update camera firmware to the latest version –
use JABLOTOOL, Configuration, Control panel, Firmware upgrade.
EYE-02 User Guide
- in short range radio transceiver which offers a cooperation with wide
detail
ed guide to troubleshooting.
Your SIM card is out-of-service or blocked by a PIN code – remove the SIM
card form the camera, put it into your GSM phone and try to make a call
and send an SMS. If PIN protected please remove the PIN or set it to
Your SIM card isn't placed in the SIM holder correctly, or the camera
doesn't support your SIM card type. Check if the SIM card is placed in the
Check the quality of GSM network signal directly at the place of camera
installation – put there your mobile phone, wait a few seconds and read
the signal strength from your phone LCD. If signal is too low you might try
to replace original camera GSM antenna by some optional approved type
Check the battery in your remote controller/ – press a button and check if
the light on your controller goes on. If not, replace the controller internal
Use PC with JabloTool software, open the ENROLL mode and press any
- 17 -
Solution
default network value.
holder correctly or contact your GSM service provider.
with higher gain.
battery.
button of your remote control to enroll it to camera