Table of Contents
Advertisement
7.
GENERIC COMMANDS
7.1 V.25TER
7.1.1 Z Reset to default configuration
Command
Description
execute
disconnect, reset to stored profile 0
Z[0]
disconnect, reset to stored profile 1
Z1
Mandatory. V.25ter section 6.1.1. Settings that are not stored in a profile (refer &W) will be
reset to their factory defaults (refer &F (Z resets also all fax commands)). Even when the
product would not have memory profiles (or only one of them), it shall accept both Z0 and Z1
(and reset to factory defaults). Additional commands on the same command line after the Z
command will be ignored. Note: profile is saved to the Nokia D211 card and it is NOT the
same as a Profile in the Nokia D211 windows UI.
7.1.2 &F Set to factory-defined configuration
Command
Description
execute
reset to factory defaults
&F[0]
Mandatory. V.25ter section 6.1.2. Command parameters (if implemented) that are reset to
their factory defaults are: All S-registers, E, Q, V, X, &C, &D, +IFC, +ILRR, &S, +CSCS, +DS,
+DR, +ES, +ER, +CSTA, +CMOD, +CBST, +CRLP, +CR, +CRC, +CSNS, +CHST, +CHSN, +CV120
(only <mfm>), +CVHU, +CREG, +COPS (only <format>), +CLIP, +CLIR, +COLP, +CCWA (only
<n>), +CUSD (only <n>), +CSSN, +CPBS, +CMEE, SMS commands, GPRS commands, Fax
commands (except +FCLASS , and Class 2.0 specific parameters when +FCLASS = 2.0).
45/113
Advertisement
Table of Contents
