adjusting the Base Visual ringer
Visual ringer
The visual ringer blinks for the following conditions:
• Incoming call - outside line
• Incoming call - intercom or intercom hold
You can change the brightness of the base visual
ringer. The VISUAL RINGER switch is on the right-hand side
of the base. Slide the switch to HIGH, LOW, or OFF. (It
doesn't affect the audio ringers.)
using the audio Boost
You can increase the earpiece volume for normal calls and intercom calls. During a call,
press BOOST. Press BOOST again to turn it off.
DnD (Do not Disturb) Mode
• You can silence the ringers on the base and all handsets at the same time. It doesn't
affect the visual ringers.
• With the phone in standby, press and hold DND on the base. The phone automatically
turns on the answering system and shows DND Mode On in the display on each
handset. (The answering system answers any incoming calls without playing
anything through the speaker.)
• To cancel, press DND or #/DND again.
If you turn the ans system off while DND mode is on, the phone turns off DND mode.
25