Resetting Base; Registering A Handset - Uniden XDECT SSE37 Series Owner's Manual

Installing a line Filter or Dsl Filter
A telephone line filter or DSL filter prevents services that use the phone line from
causing interference on your phone. To get a line filter, contact your service provider or
look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter. Make a test
call to make sure the noise is gone.
liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adaptor and phone
cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and use as
normal. If you can hear liquid inside the housing:
1. Disconnect all cables and cords and remove all compartment covers.
2. If liquid is leaking from any vent or hole, turn the phone so that vent faces down. If
not, place the largest vent face down.
3. Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers and reconnecting cords.

resetting Base

If you have trouble with the base, unplug the base to reset it. Plug it back in after at least
a minute. If you have trouble with a cordless handset or if you want to replace one, reset
it:
1. Press and hold END/CLEAR and # at the same time until System Reset displays (about
5 seconds).
2. If you still have the base the handset is registered to, select Deregister HS, then
select the handset you want to reset. If you don't have that base anymore, select
Base Unavailable.
3. To confirm, select Yes. The handset displays Handset not registered.

registering a handset

If you see a "not registered" message on a handset, you must register it to a base
before using it.
1. On the base, open the menu and select Register Accy.
2. On the handset, press and hold #/DND until the handset display says Handset
Registering (about 2 seconds).
3. Wait until the handset display says Registration Complete (about 30 seconds), then
pick up the handset.
# If you don't hear a dial tone or the display says Registration Failed, charge the
battery completely, then try again.
35