Accessing The Answering System; Recording Your Personal Greeting - Uniden XDECT SSE37 Series Owner's Manual

accessing the answering system

With the phone in standby, you can access your system
from the base or remotely from any handset. Only 1
handset or the base can access the system at a time.
During remote access;
• The system beeps so you know it's waiting for your
next command.
• You can press the number key shown next to each
command instead of scrolling through the screens.
1. Press MENU/OK and select Messages/Play Messages to
listen to your answering system messages. The LCD displays CID information for the
current message.
2. The LCD also displays actions you can take while the message is playing. Press the
number on the keypad that corresponds to the action you want to take. If you stop
the message, the LCD displays 2:Play instead of 5:Stop.

recording your personal greeting

Your personal outgoing message or greeting can be between 2 seconds and 30
seconds long. If you don't want to record a greeting, the system uses the pre-recorded
greeting: Hello, no one is available to take your call. Please leave a message after the
tone.
From the Base
1. Open the menu and select
Setup/Record
2. Press SELECT/MENU again. Wait until the
system says "Record greeting" before
speaking.
3. Press PLAY/STOP to stop recording. The
system plays back your new greeting.
4. To keep this greeting, press PLAY/STOP.
To re-record it, go back to step 2.
switch Between greetings
From the Base
1. Open the menu and select
Setup. Then select
2. The system plays back the current
greeting.
3. Press OK to switch greetings.
30
Answering
Greeting.
Answering
Greeting Options.
From a Cordless Handset
1. Access the Answering Setup menu
and select Record Greeting.
2. Press MENU/OK, a message displays,
To Start, Press Ok. Press MENU/
OK. Wait until the system prompts
"Record greeting" before speaking.
3. Press MENU/OK to stop recording. The
system plays back your new greeting.
4. To keep this greeting, press END/CLEAR.
To re-record it, go back to step 2.
From a Cordless Handset
1. Press MENU/OK and select Answering
Setup/Greeting Options.
2. The current outgoing message plays.
3. During playback, press MENU/OK to
switch between the preset outgoing
message and the message you
created.
24/05