Uniden XDECT SSE37 Series Owner's Manual page 6

remove the stand
Press in on the latches and slide them out of the notches.
Connect the Corded Handset
Use the coiled cord to connect the
corded handset to the connector on
the left side of the base.
1
2
Connect the power and telephone Cords
1. Connect the base AC adaptor to the power jack and the telephone cord to the TEL
LINE jack. Route the cords as shown below:
For desktop use
DESK
WALL
2. Plug the AC adaptor into a standard 240V AC power outlet, and connect the
telephone cord to a standard telephone wall jack.
3. If you are mounting the phone on the wall, place the mounting slots over the pins on
the wall plate, and slide the base down to lock it into place.
6
For wall mount use only
1. On the front of the base, slide the clip out of its
2. Rotate the clip 180 degrees.
3. Flip it from front to back and slide it back into
3
slot.
the slot.
For wall mount use
DESK
WALL