Kenmore 721.86012 Installation Instructions Manual page 18

STEP 6:
ATTACH THE OVEN TO THE WALL
5. Roof vented installation: See Figure 32.
Install ductwork through the vent opening in the
upper cabinet. Complete the venting system
through the roof according to the method
needed. See "PREPARE THE VENTING
SYSTEM," STEP 2 on the page 8. Use caulking
to seal exterior roof opening around the
exhaust cap. See Figure 6 on page 8.
6. Use power supply cord clamp to bundle the
power supply cord. Install the power supply
cord clamp, using a screw as shown in
Figure 33, to inside of the cabinet.
7. To install the grease filter: Slide it into the slide
slot, then push up and toward oven center to
lock. See Figure 34.
8. Plug in the power supply cord.
9. Read your Owner's Manual, then check the
operation of your microwave oven.
18
damper
Figure 32
duct
Figure 33
Figure 34
power
supply
cord
clamp