Kenmore 721.86012 Installation Instructions Manual page 15

THE OVEN MUST BE CONNECTED
TO AT LEAST ONE WALL STUD.
1. Draw a vertical line on the wall at the center of the
30" wide space.
Use the mounting plate as the template for the
rear wall. Place the mounting plate on the wall,
making sure that the tabs are against the bottom
of the cabinet. Line up the notch and center line
on the mounting plate to the center line on the
wall.
2. While holding the mounting plate with one hand,
draw circles on the wall at holes "A", "B", "C"
and "D". Four holes must be used for mounting. If
the holes are not used, the installation will not be
secure. Installer must use these holes for proper
installation. Use toggle bolts through these holes
unless one of them lines up with a stud. Use a lag
screw for studs. See Figure 26.
NOTE: Draw a fifth circle inside area "E", through
one of the holes to match the location of a
stud.
For wall vented: The oven requires a rear wall
cutout opening for the rear wall duct and the
exhaust adaptor must be attached to the mounting
plate. See the next page on how to prepare the rear
wall cutout opening and the exhaust
adaptor/mounting plate for wall vented.
3. Drill holes through the circles. If there is a stud,
drill a 3/16" hole for lag screws. Two or preferably
four lag screws at holes "A" and "C", or "B" and
"D" must be used to secure mounting plate to
wall. If there is no stud, drill a 3/4" hole for toggle
bolts. Make sure to use at least 1 lag screw at
holes of area "E" in a stud, and 4 toggle bolts at
holes "A", "B", "C" and "D" in the drywall or the
plaster.
4. Attach the plate to the wall. To use spring toggle
head bolts: Remove the toggle wings from the
bolts. Insert the bolts into the mounting plate and
replace the spring toggle heads to 3/4" past the
bolt ends. Insert the spring toggle heads into the
holes in the wall to mount the bracket. You may
pull forward on the bracket to help in tightening
the toggle bolts. Tighten all bolts. See Figure 27.
STEP 5: INSTALL THE MOUNTING
PLATE TO THE WALL
5/8" Hole on Drywall Only
Minimum 66"
From the Floor
Mounting
Plate
A
Center Line
C
Support Tab
(1-piece Mounting Plate)
5/8" Hole on Drywall Only
Minimum 66"
From the Floor
A
Center Line
C
Support Tab
(3-piece Mounting Plate)
Figure 26
Space More Than Wall Thickness
Toggle Wings
Mounting
Plate
Toggle Bolt
Wall
Figure 27
3/16" Hole on Studs
For Wall-
Vented Only
Draw Lines
on Studs
Draw
Center Line
B
D
E
Support Tab
3/16" Hole on Studs
For Wall-
Vented Only
Draw Lines
on Studs
Draw
Center Line
B
Mounting
Plate
D
E
Support Tab
Bolt
End
15