Biddle DF Manual page 22

en
I
NSTALLATION
en-22
You can connect one or more of these units to a single con-
trol panel in combination with other units. The following
applies in this regard:
• A unit with two control PCBs counts as two units.
• A unit with two control PBCs is always the master unit.
Units with a single control PCB must be configured as nor-
mal units.
• If several units have two control PCBs, then one of these
units is configured as the master unit. All control PCBs in
all other units must be configured as normal units.
• The control panel and the external control components
must always be connected to the master unit.
2.7.7 Mounting and connecting control panel
1. Open the control panel.
2. Feed the control cable through an opening in the rear
plate.
3. Attach the rear plate to the wall.
C A C
OMFORT IR URTAIN