Table of Contents
Advertisement
DF M
ANUAL
Manual version 2.0 (26-10-2012)
M
AXIMUM CURRENT ON
L1, L2
L3
TYPE PLATE
OR
<= 80 A
<= 102 A
Note:
n
Multiple units may only be served by a common fuse
is their total current consumption is less than 10A.
2.6.3 Connect the unit
For units supplied without a mains power cable/plug
only:
Warning:
w
Only connect the unit if you are qualified to
work on three-phase power systems.
Make sure that the mains power supply has
been turned off.
1. Fit the isolation switch and connect it to the power supply.
2. Open the unit.
3. Feed the power cable through the cable gland 1.
4. Connect the cable to the unit's power terminal 2 as
shown in the wiring diagram.
5. Connect the power supply cable to the isolation switch.
Caution:
c
Do not yet switch the mains supply on.
See also:
6.2.2 "Opening the unit" on page 37
I
NSTALLATION
M
A
AXIMUM FUSE VALUE
100 A
125 A
en-17
en
Advertisement
Table of Contents
