Battery; Fuse - RIEJU TANGO 125 Owner's Manual

Tango 125 motorcycle
Hide thumbs Also See for TANGO 125:
Table of Contents

Advertisement

Available languages

Available languages

manual tango 125-ing jun2010.qxp
14/06/2010
11:59
Página 11

Fuse

BATTERY

Open the seat with the key to reach the battery.
The terminal block should be checked, together with the actual ter-
minals themselves.
If any oxide is observed on the terminal block or the ends of the
terminals, this should be cleaned off with a metal bristle brush,
sandpaper or similar. Once the cleaning operation has been com-
pleted, the terminals should be connected again and grease
applied to their ends and the terminal block.
Correct connection must be verified, otherwise the battery could
be damaged.
Special attention should be applied to battery handling, since this
contains sulphuric acid and you may run the risk of burning your
skin, eyes and clothing. It should also be kept away from flames, sparks and cigarettes.
If it should ever become necessary to replace the battery, then the same battery type should be fitted.
FUSE
The installation has two fuses, to accede to these it is had to clear the saddle and to disassemble the late-
ral plate. The fuse of 7.5 A corresponds to the circuit of illumination and the one of 15 A is the general
fuse of the motorcycle. If the fuse should blow, switch off the engine and replace it with one of the same
amps. Turn the ignition on again and verify electrical system operation.
The fuse must never be replaced by one of a higher current rating since this could damage and even burn
the electrical system.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents