Table of Contents
Advertisement
BATTERY
The seat has to be removed in order to reach the battery, this is
accomplished by loosening the screw under the rear mudguard
and pulling the seat backwards.
The terminal block should be checked, together with the actual
terminals themselves.
If any oxide is observed on the terminal block or the ends of the
terminals, this should be cleaned off with a metal bristle brush,
sandpaper or similar. Once the cleaning operation has been com-
pleted, the terminals should be connected again and grease
applied to their ends and the terminal block.
Correct connection must be verified, otherwise the battery could
be damaged.
Special attention should be applied to battery handling, since this contains sulphuric acid and you may
run the risk of burning your skin, eyes and clothing. It should also be kept away from flames, sparks and
cigarettes.
If it should ever become necessary to replace the battery, then the same battery type should be fitted.
FUSE
The fuse is 10 Amps and is located next to the battery, under the seat. If the fuse should blow, switch off
the engine and replace it with one of the same amps. Turn the ignition on again and verify electrical sys-
tem operation.
The fuse must never be replaced by one of a higher current rating since this could damage and even burn
the electrical system.
11
Advertisement
Table of Contents
