Filtersand Sand & Initial Preparation; Safety Notes; Damage During Delivery; Implied Warranty - Steinbach Speedclean Comfort 75 Owner's Manual

Speedclean Comfort 75 / Speedclean Comfort 50
2.4 Filtersand Sand & Initial Preparation
The filter system you have purchased requires a specific type of sand (not included) for optimum operation:
namely, No.20 Silica Sand,
most pool supply stores. While the sand will come packaged, it is important that the sand be cleaned prior to run-
ning the filter system in filtration
your pool which can be difficult to
in the initial set up section provided in this manual.
2.5

Safety Notes

Your filter pump was constructed and tested and left the manufacturing plant in technically operational
In order to maintain this condition and ensure safe operation, the user should observe the notes and product in-
formation contained in this technical
the device is to be disconnected from the power supply and secured against accidental use.
This is the case when:
 The device has visible damage
 The device no longer appears funcional
 After long periods of storage in poor conditions
2.6

Damage During Delivery

Your filter system has been carefully and professionally packed for
package is undamaged and that all parts are in the box. If you purchased this product on order and the product
was shipped to you, ensure that delivery is
sponsibility of the supplier and must be immediately reported to the shipper.
damages during delivery, the supplier is not responsible for it.
2.7

Implied Warranty

The manufacturer warranties safe operation and reliability only under the following conditions:
 The filter system is installed and operated according to the assembly and operating instructions.
 Only original replacement parts are used (consumable parts do not fall under the warranty).
Expendable parts do not fall under the warranty. These include:
 All O-rings
 Pressure gauge
 Mechanical seal, complete
2.8

Resultant Damages

We cannot be responsible for damages to the product if the product is not used in accordance with the instruc-
tions provided.
2011_V1
double burned, with a particle size of 0.4 mm -
mode. Failing to pre-clean the sand will result in tiny and dusty sand sediment in
remove. Therefore, please read and follow the instructions for cleaning the sand
handbook. If there is any indication that safe operation is no longer possible,
complete.
page 6 of 21
0.8 mm.
delivery. Please check to ensure that the
Damage to product as a result of shipping is not the re-
The shipper assumes the liability for
You can purchase this sand at
condition.