Connecting The Filter System - Steinbach Speedclean Comfort 75 Owner's Manual

Speedclean Comfort 75 / Speedclean Comfort 50
7. Hooking up the hoses
a) Lightly lubricate the 1¼" – 1½" hose connector
the Pump with petroleum jelly.
b) Attach the filter-pump hose to the
water pump.
c) Secure with a hose clamp.
NOTE: If your system came with a threaded filter-pump hose, you will not need the 1¼" – 1½" hose connector.
Rather screw the hose into the center port of the water pump directly with O-ring "A" in between.
8. Connecting Filter Hose to the Tank
a) First lightly lubricate the tank intake port (Tank Intake) on the
tank cover with petroleum jelly.
b) Attach the loose end of the filter-pump hose to the tank intake
port on the tank cover.
c) Secure with hose clamp.
9. Filter – Pump Assembly
The basic Filter-to-Pump Assembly should resemble the figure shown
at right.
6 Connecting the Filter
The next section outlines installation instructions for connecting the Sand Filter System to your
begin make sure you KNOW YOUR POOL (page 10)
This pool filter system is designed to connect to pools with standard 1¼ or 1½" diameter hose connectors. The
type Speedclean Comfort 75 has a 2 ¼" (Ø 32 mm or 38 mm) hose adapter for Intex® pools (see section entitled
"For Pools WITH Threaded Hose Connectors" on page 14). If your pool has a hose connector size and/or type dif-
ferent than described here, you may need to purchase an adapter at your local pool supply store or hardware re-
tailer.
Since the hoses utilized for filtration and return lines differ for various types of above-ground pools, the pool-filter
connection section is broken down by pool hose size and type.
Before you begin to connect hoses to the filter and pump, make certain that no water can flow through the intake
or return hoses connected to the pool. Some pools have shut off valves in their intake and return ports, others do
not. If you do not have a shut off valve, block the ports with a removable plug to prevent water from passing into
and through the hoses
.
2011_V1
(Pump Intake) on
1¼"-1½" hose connector on the
System
ADVICE
page 13 of 21
pool. Before you