Filter Operations - Steinbach Speedclean Comfort 75 Owner's Manual

Speedclean Comfort 75 / Speedclean Comfort 50

7 Filter Operations

Before moving on to the Startup Section, please make yourself familiar with your new filtering system's valve set-
tings and functions.
Setting
Function: Vacuum, regular pool filter action. This
is the setting the filter will be set to most of the
time.
top of the filter where it compresses and flattens
down the sand. Contaminants are trapped by the
sand as water makes it way to the bottom strain-
Filtration
er, out of the filter and back to the pool.
Position 1
Function: Use after backwashing to clean the fil-
ter
after backwashing, new sand addition or filter
start-up.
top of the tank where it flushes the valve while
sending water out the waste line.
Rinse
Position 2
Function: circulate water after chemical treat-
ment.
cleanups and chemical treatments when you
don't want the water contaminating the
this position, water is only directed through the
valve back to the pool and does not filter through
Circulation
the sand.
Position 3
Function: clean filter of captured
the position needed to clean the filter/the
You'll know it is time to backwash when the pres-
sure gauge rises 0,3 to 0,6 bar above what it
normally reads when the filter is
sition, water is directed through the bottom
strainer, reversing the flow through the
Backwash
causes the sand to separate and lift while releas-
ing trapped debris out the waste line.
Position 4
2011_V1
Complete Water Flow/Function
In this position, water is directed through the
bed. This should always be done immediately
In this position, water is directed to the
This position is used during certain pool
page 16 of 21
sand. In
debris. This is
sand.
clean. In this po-
tank. This
Valve Diagram