To Clean The Hair And Lint Filter On The Motor/Pump Assembly; To Winterize The System - Steinbach Speedclean Comfort 75 Owner's Manual

Speedclean Comfort 75 / Speedclean Comfort 50
8.1

To Clean the Hair and Lint Filter on the Motor/Pump Assembly

1) Unplug the pump from the power source.
2) Close the shutoff valves or block the water flow at the pool inlet port (Skimmer).
3) Place valve in the #5 – Closed position.
4) Remove the transparent hair & lint strainer cover on the pump by
out the strainer basket, clean it, and replace
ten threaded collar. Tighten securely but do not over tighten
5) Open the shutoff valves or unblock the water flow at the pool inlet port.
6) Place valve in #1 – filtration position.
7) Reconnect to power source.
Never operate the pump without the hair and lint strainer basket in place – this can cause damage to the motor
and pump assembly
.
8.2

To Winterize the System

1) Unplug the pump from the power source.
2) Close the shut off valves or block the flow of water at the pool inlet and
3) Disconnect the filtration system from the pool, drain the tank and hoses.
4) Place the handle on the central valve in position 7- 'Winterize' to relieve the
ternal valve components
5) Store the filter system in a location protected from frost and severely cold temperatures.
insulated storage shed is
2011_V1
it. Replace the
IMPORTANT
.
recommended.
page 20 of 21
unscrewing the threaded
transparent hair & lint strainer cover
.
return ports.
tension on the spring and in-
collar. Take
and tigh-
In a garage or