Alarm Output Tab - Setting The Alarm Output; Periodical Execution; Memory Card Trouble Detection; Trouble Sending - Sony Ipela SNC-WR630 User Manual

and sequential number (2 digits), thus adding 14-
digit number to the image file name.

Periodical execution

You can set to send e-mails periodically.
Image file name
Type the file name you want to assign to the image to be
attached to an e-mail. You can use up to 10
alphanumeric characters, – (hyphen) and _ (underscore)
for naming.
The actual image file name will be the specified image
file name with a suffix and the extension .jpg.
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits the
year (2 digits), month (2 digits), date (2 digits), hour
(2 digits), minutes (2 digits) and seconds (2 digits),
and sequential number (2 digits), thus adding a 14-
digit number to the image file name.

Trouble sending

Set to send an e-mail when a memory card problem or
fan problem is detected.
Enable
Select the checkbox to enable the sending of problem
reports.
Continuous sending
Set whether to enable continuous e-mail sending.
When the checkbox is selected, an e-mail will be sent
once an hour.
Recipient e-mail address
Type the recipient's e-mail address within 64 characters.
OK/Cancel
See "Buttons common to every menu" on page 21.
Alarm output Tab — Setting the
Alarm output
You can perform setting in this menu to control the
alarm output of the I/O port on the rear of the camera
linked to alarm detection function.
58
Setting the Action output — Action output Menu
Tip
For details on connection of peripheral devices to the
alarm output of the I/O port, refer to the supplied
Installation Manual.
Duration
Duration 1, 2
Enter the duration for which the alarm is output,
between 1 sec. and 60 sec.

Memory card trouble detection

Set to output the alarm when trouble of the memory card
is detected.
Output port 1, 2
Check the I/O port number that outputs the alarm when
the trouble of memory card is detected.
OK/Cancel
See "Buttons common to every menu" on page 21.