Alarm Output Tab - Setting The Alarm Output; Edge Storage Tab - Setting The Edge Storage Movie And Still Image Function - Sony SNC-VB635 User Manual

Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits of
the year (2 digits), month (2 digits), date (2 digits),
hour (2 digits), minute (2 digits), second (2 digits),
and sequential number (2 digits), thus adding 14-
digit number to the image file name.
Periodical execution
You can set to send e-mails periodically.
Image file name
Type the file name of the image attached to the e-mail
using up to 10 alphanumeric characters, – (hyphen) and
_ (under score).
The actual image file name will be the specified image
file name with a suffix and the extension .jpg.
Suffix
Select a suffix to be added to the file name used when the
e-mail is sent.
None: The name of the sent file will be the image file
name.
Date & time: The date & time suffix is added to the
image file name.
The date & time suffix consists of last two-digits the
year (2 digits), month (2 digits), date (2 digits), hour
(2 digits), minutes (2 digits) and seconds (2 digits),
and sequential number (2 digits), thus adding a 14-
digit number to the image file name.
Trouble sending
Select the checkbox to enable the sending of problem
reports.
Continuous sending
Set whether to enable continuous e-mail sending.
When the checkbox is selected, an e-mail will be sent
once an hour.
Recipient e-mail address
Type the recipient's e-mail address within 64 characters.
OK/Cancel
See "Buttons common to every menu" on page 18.
Alarm output Tab — Setting the
Alarm output
You can perform setting in this menu to control the
alarm output of the I/O port on the rear of the camera
linked to alarm detection function.
48
Setting the Action output — Action output Menu
Tip
For details on connection of peripheral devices to the
alarm output of the I/O port, refer to the supplied
Installation Manual.
Duration
Duration 1, 2
Enter the duration for which the alarm is output,
between 1 sec. and 60 sec.
OK/Cancel
See "Buttons common to every menu" on page 18.
Edge Storage Tab — Setting the
Edge Storage movie and still image
function
With Edge Storage, video or audio signal can be
recorded from the alarm detection results, such as
network block, recorded video and audio can be
streamed with the same protocol as the real-tim
streaming.
Notes
• The frame rate and operability on the viewer may be
reduced during movie or still image recording.
• The actual interval of recording a still image may be
longer than the interval you set.
• Stop the Edge Storage recording before you turn off
the power of the camera with a memory card inserted.
• Before you remove or insert a card, stop the Edge
Storage recording and turn off the power of the
camera.
• Before using a memory card, format it using the
computer, or by Format memory card in the
Initialize tab of the System menu (page 20).
• The supplied ActiveX viewer is not used for streaming
the recorded video or audio data. For details on
supported applications, contact an authorized Sony
dealer.
• A maximum of 500 movie records can be saved to an
memory card. If the checkbox of Overwrite is not
selected when the number of records reaches 500, new
recordings cannot be made. If the checkbox of
Overwrite is selected when the number of records
reaches 500, the unit will begin to overwrite old
records in ascending chronological order.
• Overwrite is not available for a memory card of less
than 4 GB.