Using Dap Modes (Front Panel) - JVC RX-E100SL Instructions Manual

CENTER : To adjust the center speaker output level
(from –10 to +10).
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
EFFECT : To adjust the DSP effect level. As the number
increases, the effect becomes stronger (normally set
it to "EFFECT 3").
* "0" is the initial setting for the speaker output levels, and
"EFFECT 3" is for the DSP effect level.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to make an
adjustment.
• When adjusting the speaker output levels, make adjustments
so that the sound level of the selected speaker is set at the
same level as that of the front speakers.
CONTROL
ANALOG L C R PRO LOGIC
DSP
LPCM
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
Ex.: When adjusting the center speaker output level
6 4 5
Repeat steps and
adjustments.
To cancel Theater Surround
Press DSP MODE repeatedly until "STEREO" appears on the
display. The PRO LOGIC and DSP indicators go off.

Using DAP Modes (Front Panel)

A DAP mode cannot be used with another DSP mode. Once one of
the DAP modes is activated, the other DSP mode in use will be
canceled.
• You have to make this adjustment for each source.
• You cannot use any DAP mode if no rear speakers are connected.
1
Select and play stereo analog software or Linear
PCM digital software.
2
Press DSP MODE repeatedly until one of the
DAP modes appears on the display.
The DSP indicator lights up on the display.
DSP
MODE
ANALOG L R
DSP
SUBWFR
LS S RS
(back to the begining)
VOL
to make other
VOL
3
Press ADJUST.
The CONTROL buttons now work for sound
ADJUST
adjustments.
4
Press CONTROL ∞ (or 5) repeatedly until one
of the following indications (with the current
setting) appears.
*
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
EFFECT : To adjust the DSP effect level. As the number
increases, the effect becomes stronger (normally set
it to "EFFECT 3").
* "0" is the initial setting for the speaker output levels, and
"EFFECT 3" is for the DSP effect level.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to make an
adjustment.
• When adjusting the speaker output levels, make adjustments
so that the sound level of the selected speaker is set at the
same level as that of the front speakers.
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
Ex.: When adjusting the left rear speaker output level
6 4 5
Repeat steps and
adjustments.
To cancel DAP Mode
Press DSP MODE repeatedly so that "STEREO" appears on the
display. The DSP indicator goes off.
VOL
VOL
to make other
31