JVC RX-E100SL Instructions Manual page 29

2
Press DSP MODE repeatedly until "THEATER"
appears on the display.
The PRO LOGIC and DSP indicator light up on the display.
DSP MODE
ANALOG L R
SUBWFR
3
Press SOUND.
The 10 keys now work for sound adjustments.
SOUND
4
Press TEST to check the speaker output balance.
TEST
1
O LOGIC
P
TL AUTO
PUT ATT
"TEST L" starts flashing on the display, and a test tone comes
out of the speakers in the following order:
(Left front speaker) (Center speaker)
(Left rear speaker)
Notes:
• You can adjust the speaker output levels without outputting the
test tone.
• No test tone comes out of the center speaker when "CTR SP"
is set to "NO."
5
Adjust the following speaker output levels
(from –10 to +10).
• Make adjustments so that the sound level of the selected
speaker is set at the same level as that of the front speakers.
To adjust the center speaker level, press CENTER +/–.
– CENTER +
ANALOG PRO LOGIC
L C R
5
6
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
To adjust the left rear speaker level, press REAR•L +/–.
– REAR•L +
8 9
ANALOG L C R PRO LOGIC
5
DSP
LPCM
SUBWFR LFE MENU
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
To adjust the right rear speaker level, press REAR•R +/–.
– REAR•R +
0 +10
ANALOG L C R PRO LOGIC
LPCM DSP
ENTER
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
PRO LOGIC
DSP
VOL
(Right front speaker)
(Right rear speaker)
VOL
VOL
VOL
6
Press TEST again to stop the test tone.
TEST
1
GIC
UTO
TT
7
Press EFFECT to select the DSP effect level (1 to
5) you want.
• As the number increases, the DSP effect becomes stronger
(normally set it to "EFFECT 3").
EFFECT
4
ANALOG L R PRO LOGIC
DSP
SUBWFR
LS S RS
To cancel Theater Surround
Press DSP MODE repeatedly until "STEREO" appears on the
display. The PRO LOGIC and DSP indicators go off.
VOL
VOL
27