Using Theater Surround (Front Panel) - JVC RX-E100SL Instructions Manual

Creating Realistic Sound Fields
STANDBY
POWER
CENTER : To adjust the center speaker output level
(from –10 to +10).
REAR L : To adjust the left rear speaker output level
(from –10 to +10).
REAR R : To adjust the right rear speaker output level
(from –10 to +10).
* "0" is the initial setting for these speaker output levels.
If you have already changed the setting, another setting will be
shown.
5
Press CONTROL 3 (or 2) to adjust the speaker
output level.
• Make adjustments so that the sound level of the selected
speaker is set at the same level as that of the front speakers.
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DGTL AUTO
DOLBY D
LS S RS
DTS INPUT ATT
Ex.: When adjusting the center speaker output level
6 4 5
Repeat steps and
levels.
To cancel Surround Mode
Press SURROUND ON/OFF again so that "STEREO" appears on
the display.
• If Surround mode is canceled while playing back multichannel
digital software, all channel signals are mixed and output through
the front speakers (and subwoofer if you have connected a
subwoofer and set the subwoofer setting correctly – "YES.")
30
CONTROL
5/∞/3/2
TV DILECT
ANALOG L
CONTROL
LPCM
SUBWFR LFE
DOLBY D
LS
DTS
ADJUST MEMORY
SETTING
D I G I T A L
DVD DVD
D I G I T A L
S U R R O U N D
ADJUST
VOL
to adjust the other speaker
Display
RX-E100 HOME THEATER RECEIVER
C R PRO LOGIC SLEEP TUNED ST AUTO MUTING
DSP MH
Z
DGTL AUTO KH
Z
INPUT
S RS VOL
INPUT ATT
ANALOG/DIGITAL
INPUT ATT
TV VCR CD FM AM

Using Theater Surround (Front Panel)

Theater Surround cannot be used with another DSP mode. Once
Theater Surround is activated, the other DSP mode in use will be
canceled.
When using the buttons on the front panel, no test tone is available.
Make adjustments while listening to the sound of the source played
back.
• You have to make this adjustment for each source.
• You cannot use Theater Surround if no rear speakers are
connected.
1
Select and play software encoded with Dolby
Surround.
2
Press DSP MODE repeatedly until "THEATER"
appears on the display.
The PRO LOGIC and DSP indicators light up on the display.
DSP
MODE
3
Press ADJUST.
ADJUST The CONTROL buttons now work for sound
adjustments.
4
Press CONTROL ∞ (or 5) repeatedly until one
of the following indications (with the current
setting) appears.
*
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SURROUND DSP
ON/OFF MODE
MASTER VOLUME
DSP
MODE
ANALOG L R PRO LOGIC
DSP
SUBWFR
VOL