Basic Settings; Setting The Digital Input Terminals - JVC RX-E100SL Instructions Manual

Basic Settings

STANDBY
POWER
D I G I T A L
S U R R O U N D
SETTING
Setting the Digital Input
Terminals
When you use the digital input terminals, register what components
are connected to which terminals (DIGITAL IN 1/2) so that the
correct source name will appear when you select the digital source.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"DGT (Digital)" (with the current setting)
appears on the display.
CONTROL
* "1DVD2TV" is the initial setting. If you have already changed
the setting, another combination will be shown.
10
CONTROL
5/∞/3/2
TV DILECT RX-E100
ANALOG L C R PRO LOGIC
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD
DVD TV
D I G I T A L
Source selecting buttons
(DVD, TV, CD)
Remote
NOT
*
VOL
Display
HOME THEATER RECEIVER
SLEEP TUNED ST AUTO MUTING
MH
Z
KH
Z SURROUND
INPUT
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR CD FM AM
INPUT
ANALOG/DIGITAL
3
Press CONTROL 3 (or 2) to select the
appropriate digital terminal setting.
• Each time you press the button, the display changes to show
the following:
CONTROL
ANALOG L C R PRO LOGIC
DSP
LPCM
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
(back to the begining)
Note:
When shipped from the factory, the DIGITAL IN terminals have been
set for use with the following components.
• DIGITAL 1 (coaxial): For DVD player
• DIGITAL 2 (optical): For digital TV tuner
DSP
MODE
MASTER VOLUME
VOL