Setting The Subwoofer Information; Setting The Speakers For Dsp Modes - JVC RX-E100SL Instructions Manual

Basic Settings
STANDBY
POWER
D I G I T A L
S U R R O U N D
SETTING

Setting the Subwoofer Information

When you have connected a subwoofer, follow the procedure below.
If you do not use a subwoofer, you can skip this setting.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
SETTING
The CONTROL buttons now work for basic
settings.
2
Press CONTROL ∞ (or 5) repeatedly until
"SUBWFR (Subwoofer)" (with the current
setting) appears on the display.
*
CONTROL
GIC
UTO
TT
* "NO" is the initial setting. If you have already changed the
setting, "YES" will be shown.
3
Press CONTROL 3 (or 2) to select "YES."
• Each time you press the button, the subwoofer setting
alternates between "YES" and "NO."
CONTROL
ANALOG L C R PRO LOGIC
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
YES : Select this when a subwoofer is used.
The subwoofer speaker indicator (SUBWFR) lights
up on the display (see page 9). You can adjust the
subwoofer output level (see page 19).
NO
: Select this when you have not connected or have
disconnected a subwoofer.
12
CONTROL
5/∞/3/2
TV DILECT RX-E100
ANALOG L C R PRO LOGIC
CONTROL
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
SETTING ADJUST MEMORY
DVD
DVD TV
D I G I T A L
Remote
NOT
VOL
VOL
Display
HOME THEATER RECEIVER
SLEEP TUNED ST AUTO MUTING
MH
Z
KH
Z INPUT SURROUND
VOL
ANALOG/DIGITAL ON/OFF
INPUT ATT
VCR CD FM AM
Setting the Speakers for
DSP Modes
To obtain the best possible surround effect from the DSP (Digital
Signal Processor) modes (see page 22), register the following
information after all connections are completed.
• Speaker Size — FR SP, CTR SP, REAR SP
• Delay Time — CTR DL, REAR DL
• Crossover Frequency — CROSS
• Dynamic Range Compression — D.R.C.
• Low Frequency Effect Attenuator — LFE
Speaker Size — FR SP, CTR SP, REAR SP
Register the sizes of all the connected speakers.
• When you change your speakers, register the information about
the speakers again.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
SETTING
settings.
2
Press CONTROL ∞ (or 5) repeatedly until one
of the following speakers (with the current
setting) appears.
*
CONTROL
PRO LOGIC
ANALOG L C R
LPCM DSP
SUBWFR LFE
DOLBY D DGTL AUTO
LS S RS
DTS INPUT ATT
DSP
MODE
MASTER VOLUME
Remote
NOT
VOL