Setting Up The Printer - Weidmuller SpeedMarking-Laser User Manual

2.2

Setting up the printer

• Place the device onto a solid, flat surface.
• Provide sufficient ventilation.
• The ambient conditions should be stable, e.g. the temperature and humidity fluctuations should be limited
(Temperature: 20 °C – 35 °C; Humidity: 55% – 75%).
• Avoid direct sunlight on the printer.
• The environment of the printer should be free of any chemicals.
The following dimensions show the space required for setting up the printer.
Figure 4 Space in front of and behind the printer
Figure 5 Space on both sides of the printer
Make sure that there is enough space in order:
• to open the upper cover
• to load material into the entry
• to empty the storage tray
• to be able to access the on/off switch
• to connect the mains and printer connection
• to use the operating panel
5658600000/00/05.07
Printer installation
9