Printer Maintenance - Weidmuller SpeedMarking-Laser User Manual

Printer tips and maintenance
5.4

Printer maintenance

Cleaning of the SpeedMarking-Laser
To maintain high printing quality, clean the Speed-
Marking-Laser each time after changing the special
toner cartridge. The cleaning also has to be done if
there are problems with the printing quality. In this
regard, observe the following instructions:
Keep the SpeedMarking-Laser free of dust or any
dirt particles.
Clean the outside of the housing with a slightly moist
cloth.
CAUTION
Do not use any ammonia-containing clean-
ing agents on or in the vicinity of the
SpeedMarking-Laser.
• Over time, small dust particles and toner residues
accumulate in the Speed-Marking-Laser. This can
lead to white strips on the printout. After cleaning,
you will get a normal printing result.
WARNING
Switch off the SpeedMarking-Laser and
pull the mains cable before you start clean-
ing the SpeedMarking-Laser.
1 Open the cover of the SpeedMarking-Laser.
2 Take the toner cartridge out of the SpeedMark-
ing-Laser.
CAUTION
To avoid any damages, the toner cartridge
should be exposed to the sunlight only for
a few minutes.
22
3 With a dry and lint-free cloth, remove any dust,
dirt, toner and possible adhesive elements out of
the printing area.
Figure 18 Print area
4 Insert the toner cartridge again into the Speed-
Marking-Laser.
5 Insert the alignment rod for the roller in its desig-
nated holding fixture.
6 Close the cover, insert the mains cable and
switch the printer on again.
5658600000/00/05.07