Safety Instructions - Weidmuller SpeedMarking-Laser User Manual

Safety instructions

1. Safety instructions
Read the following instructions carefully be-
fore starting up the SpeedMarking-Laser.
Observe the warnings and notices on the
SpeedMarking-Laser at all times.
• The mains voltage must correspond to
the system voltage given on the Speed-
Marking-Laser type plate.
• Connect the device to a properly earthed
and fused socket outlet only. Do not use
a socket outlet already being used by
devices that are turned on and off at
regular intervals, such as photocopiers
or ventilators.
• Do not connect the SpeedMarking-Laser
to either a switched or a timer-controlled
socket outlet.
Do not use the computer system close to
potential electromagnetic disturbance
fields such as loudspeakers or base trans-
ceiver stations for mobile telephones.
If you connect the SpeedMarking-Laser to
the power supply via an extension cable,
ensure that the total nominal current of all
of the devices connected to the extension
cable does not exceed the capacity for that
extension cable. In addition, you should
ensure that the total nominal current of all
the devices plugged into the wall-mounted
socket outlet does not exceed the ampere
rating for that socket outlet.
Do not carry out repairs to the device your-
self.
6
• Never use damaged or worn out power
cables.
• Connect the device to the mains only
with cable described in this guide.
• Avoid the usage of multiple cables.
• Connect the network cable directly
(never via an extension cable) to the
power socket.
• Keep the mains cable undamaged and
keep it in its original state. Do not place
any heavy objects on it. Do not pull at it
with force and do not bend it more than
necessary. A disregard of these instruc-
tions can lead to electrocution or fire.
• Place the device close to an accessible
power socket in order to be able to pull
the mains plug in case of an emergency.
• Never connect or disconnect the mains
plug to the power socket with wet hands.
There is a risk of electrocution.
Disconnect the SpeedMarking-Laser and
contact a qualified service engineer if any
of the following occurs:
• The power cord or plug are worn or dam-
aged.
• A fluid has penetrated into the Speed-
Marking-Laser.
• The SpeedMarking-Laser is allowed to
fall or the enclosure is damaged.
• The SpeedMarking-Laser does not oper-
ate normally or the standard of perform-
ance varies noticeably.
Keep any moisture or dust off the device.
Otherwise, there is the danger of fire or
electrocution.
5658600000/00/05.07