Printing Jobs; Printing Of Adhesive Backing Markers; Printing Preparation - Weidmuller SpeedMarking-Laser User Manual

4.

Printing jobs

This chapter is about printing options and printing
jobs that have to be performed regularly.
4.1 Printing of adhesive backing
markers
The Weidmüller adhesive-backing device
markers ESG, SM and CC are recogniz-
able by their brown paper material. Their
suitability for printing in the SpeedMarking-
Laser is only limited.
Please make sure that each used type of
marker has been tested and approved by
the user, by checking for any issues with
the adhesive part of the marker. In case
adhesive may leak from the marker, do not
use it.
CAUTION
Observe the following for the automatic la-
belling of the adhesive-backing markers.
The impairment of the interaction area as
well as the soiling of the roller can lead to
blotchy printing of the markers and to
damaging the device.
It is necessary to clean the Corona unit if
printing 5 MultiCards or more.
• The adhesive backing of the markers leave adhe-
sive remnants on the Corona unit of the printer.
• A roller contaminated by glue residues of the spe-
cial-toner cartridge cannot be cleaned and must
therefore be changed.
The cleaning of the Corona unit is de-
scribed under "Cleaning of the SpeedMark-
ing-Laser" in chapter 5.4 "Printer mainte-
nance".
5658600000/00/05.07
4.2

Printing preparation

Selection of media
Only markers of the Weidmüller MultiCard line with a
height of 9 mm or less can be printed with the
SpeedMarking-Laser.
You can find more information in chapter

4.1 "Printing of adhesive backing markers".

For usage of SF MultiCard strips, please
observe the chapter 3.5 "Switch for printing
SF markers".
CAUTION
It is only allowed to feed entire MultCard
strips into the printer.
Damaged or incomplete MultiCard strips
can damage the device.
As a rule, soiled or smudgy MultiCard
strips should not be used.
Each MultiCard can only be used once.
Printing jobs
19