Troubleshooting Guide - Dimplex 6905050100-500 Service Manual

TROUBLESHOOTING GUIDE

PROBLEM
General
Circuit breaker trips or fuse
blows when unit is turned on
Unit turns on or off by itself
Lights dim in room while the unit
is on
Power cord gets warm
Appearance
Fireplace does not turn on Manu-
ally
Fireplace does not turn on with
the Remote Control
Flame Frozen
Flame not bright or flame not
visible
Log set dim, not glowing
(BF9000 only)
Flame Shutter
Light leaking around the log set
CAUSE
Short in unit wiring.
Improper circuit current rating
Remote Control has a similar frequency
to other remotes in the area.
Radio frequency disturbance from out-
side sources.
Defective Remote Control Receiver
Unit is drawing close to circuit current
rating
Normal Operation
Defective Power Cord
Improper operation
No incoming power from the electrical
wall socket
Defective 3-Position Switch
Defective Remote Control Receiver
Improper operation
Remote Control not initialized to fireplace Initialize the Remote Control
Remote Control not working
Loose wiring
Defective Flicker Motor
Loose wiring
Burnt out light bulbs
Loose wiring
Defective Light Harness/ LED Light As-
sembly
Loose wiring
Defective LED Log Driver Board
Defective Log Set Assembly
Defective Flicker Motor
Log set not positioned properly
SOLUTION
Trace wiring in unit.
Additional appliances may exceed the current rating
of the circuit breaker or fuse. Plug unit into another
outlet or install unit on a dedicated 15 amp circuit.
Replace Remote Control. Initialize to Remote Control
Receiver
Replace Remote Control and Remote Control Re-
ceiver where necessary. Initialize Remote Control and
Receiver
Replace Remote Control Receiver. Initialize Remote
Control and Receiver.
Move the unit to another outlet or install unit on a dedi-
cated 15 amp circuit
The power cord may get slightly warm to the touch
when the heater is on
Replace Power Cord if cord gets hot to the touch.
Refer to Operation Section
Check fuse/breaker panel
Replace 3-Position Switch
Replace Remote Control Receiver. Initialize Remote
Control and Receiver
Refer to Operation Section
Install new battery into the Remote Control. Initialize
Remote Control.
Replace Remote Control or Remote Control Receiver
where necessary. Initialize Remote Control and
Receiver.
Check wiring connections
Replace Flicker Motor
Check wiring connections
Replace light bulbs
Check wiring connections
Replace Light Harness/ LED Light Assembly
Check wiring connections
Replace LED Log Driver Board
Replace Log Set Assembly
Replace Flicker Motor
Check log set for proper fit
17