Page 1
EF2870L 6909460159 EF2570G 6909450159 EF2570G-IR 6909451159 EF2870L Shown IMPORTANT SAFETY INFORMATION: Always read this manual first before attempting to service this fireplace. For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage.
OPERATION To disable: Press and holding the button on the unit for 5 seconds EF2870L will disable the heater, indicated by the temperature dis- play flashing. Figure 1 To enable: With the temperature displayed (it will be flashing), press and hold the button on the unit for 5 seconds to reacti- vate the heating controls.
Page 4
Press and hold the down arrow for 5 seconds to switch temperature readout from °C and °F. Disable Heat If desired, depending on the season, the heater on the unit can be disabled. The unit will operate in the same fashion, with remainder of the controls. www.dimplex.com...
Tools required: Phillips head screwdriver WARNING: Disconnect circuit power before attempt- WARNING: If the fireplace was operating prior to ser- ing any maintenance or cleaning to reduce the risk of vicing allow at least 10 minutes for the heating elements www.dimplex.com...
electric shock or damage to persons. assembly from the unit. 1. Remove the firebox out of the cabinet. 5. Disconnect the wiring connections, at the control board, and install the new heater assembly. 2. From the back of the unit remove the screws (16 on the EF2870L and 12 on the EF2570G) that secure the back 6.
EF2870L COMPONENT PICTURES Front view of unit Heater Assembly, Control board & IR Sensor Flicker Motor, Terminal Block, Flicker Rod Flame LED Assembly and Cord Set Connection Display Board (with cover and without) Control Board www.dimplex.com...
EF2570G COMPONENT PICTURES Front view of unit Heater Assembly and Control board Flicker Motor, Terminal Block and Flicker Rod Flame LED Assembly Display Board (with cover and without) Control Board and Switch Board Thermistor...
Media is not lighting up Loose wiring Check wiring connections Ember LED light assembly is not working Replace ember LED light assembly Light leaking around the log set (if ap- Log set not positioned properly Check log set for proper fit plicable) www.dimplex.com...
Need help?
Do you have a question about the EF2570G-IR and is the answer not in the manual?
Questions and answers